wet sand blasting machine is also a kind of equipment that is used more frequently now. Before use, in order to ensure the operation and use efficiency of the equipment, the packaging, storage and installation of its equipment are introduced next.
Connect to the air source and power supply of the wet sandblasting equipment, and turn on the power switch on the electrical box. According to the need to adjust the pressure of compressed air into the spray gun through the reducing valve is between 0.4 and 0.6MPa. Choose suitable abrasive injection machine bin sand must be added slowly, so as not to block.
To stop using the sandblasting machine, cut off the power and air source of the sandblasting machine. Check whether there is any abnormality in each machine, and check whether the connection of each pipeline is firm regularly. Any articles other than the specified abrasives shall not be dropped into the work compartment so as not to affect the circulation of abrasives. The surface of the workpiece to be processed shall be dry.
To stop processing in urgent need, press the emergency stop button switch, the sand blasting machine will stop working. Cut off the power and air supply to the machine. To stop the shift, first clean the workpiece, close the gun switch; Use wet sandblasting equipment to clean the abrasives attached to the working table, the inner wall of the sandblasting chamber and the mesh plate, and make them flow back to the separator. Shut down the dust removal unit. Turn off the power switch on the electrical cabinet.
Then it discusses how to replace the abrasive of the wet sand blasting machine to clean the working table, the inner wall of the sand blasting gun and the abrasive attached to the mesh plate, so that it flows back to the separator. Open the bottom plug of the sand regulating valve and collect the abrasive into a container. Add new abrasive to engine room as needed, but start the fan first.
Post time: Mar-03-2023
